Mobile repeater installation instructions

EOT mobile repeater is installed, you are not required to lose, eliminating No. disassembly operations. When the end of the column using a mobile repeater mounted on the front side of the ladder and keep the first 20 vehicles. EOT mobile repeater use lithium batteries, open the battery cover, put the battery into the battery compartment in place to move the flash fires to determine whether the repeater power basis; within mobile repeater red button is pressed, the column holding tone Taiwan has made cooing sound code to prove that the device is working properly; when you take the battery first hand bayonet pressed to pull out the battery.

If the radio antenna wires are exposed, stop in the battery compartment opening, mobile repeater set antenna wires inserted into the exposed portion of the gap at the upper part of the body to avoid when installing the battery card off antenna wires, causing the relay does not work, the formation of the end of the column failure, Train Rear affect normal use. Battery installation must be in place, the battery should pop the latch. After the battery is installed, the battery handle flat, top to avoid bad positions locks. After opening the battery door on the right side of the battery compartment has a vertical bar user interface, data acquisition it from top to bottom port,mobile booster eliminating the red button and the number of infrared receiver tube output number.
www.digood.cn